Gary Fisher CRONOS User Manual download pdf (Page 14)

GARY FISHER SERVICE INFORMATION

To install the bearings

1. Apply a liberal coat of grease to the contact surfaces of one bearing and the drive side

of the bottom bracket shell (Figure 21).

2. Slide a bearing onto the installation tool.

+ Either side of the drive-side bearing is the “right side.” The non-drive bearing on GXP systems

has a lip (Figure 22). Install the bearing so that the lip faces in.

3. Press one bearing into the drive side of the bottom bracket shell (Figure 23).

+ To remove the installation tool, press the release tab.

4. Repeat steps 1-3 for the other bearing on the non-drive side.











To install the drive-side crankarm

When handling the seals, avoid bending them. A bent seal will rub on the bearing,

creating drag.

1. Apply a light coat of grease to the bearings on the face and the axle contact surface.

2. Apply a light coat of grease to the metal inside of one bearing seal (Figure24).

Continued

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 26 27

No comments

Gary Fisher CRONOS User Manual Page 14